UltraTouch 60301-48752 Installationsanleitung

Stöbern Sie online oder laden Sie Installationsanleitung nach Nein UltraTouch 60301-48752 herunter. UltraTouch 60301-48752 Installation Guide Benutzerhandbuch

  • Herunterladen
  • Zu meinen Handbüchern hinzufügen
  • Drucken
  • Seite
    / 1
  • Inhaltsverzeichnis
  • LESEZEICHEN
  • Bewertet. / 5. Basierend auf Kundenbewertungen
Seitenansicht 0
Manufactured By Bonded Logic, Inc. Chandler, AZ 85248
Water Heater Blanket
Tools Needed:
Properly sealing and insulating your home can be an easy way to increase
comfort, save money on energy costs and increase home energy efficiency.
Completing these simple projects also means you're doing your part to
conserve the Earth's resources.
Try these other easy projects to improve home energy efficiency:
• Insulating door & window seals
• Pipe insulation
• Door bottoms
Measure to fit circumference and
height, adding a few inches to the
circumference measurement In
allow for the thickness of the
insulation.
Using your dimensions, cut the
insulation to size.
Wrap the blanket around the water
heater. Make sure to make all
appropriate cut outs for access
panels, controls, and valves.
Cut three pieces of tape, 10 inches
long. Place pieces of tape as shown in
the illustration to secure blanket. Cut a
piece of tape the same length as the
height of the waterr heater jacket.
Appy the tape to the insulation joint to
ensure the joint is closed.
Measure and cut two strips of tape
and place them on the top of the
water heater to secure the blanket.
NOTE:
* "R" means resistance to heat flow. The higher the R-Value, the
greater the insulating power. To get the marked R-Value, it is
essential that this insulation be installed properly. If you
do-it-yourself, follow the instructions carefully. Savings vary. Find
out why in the sellers fact sheet on R-values. Higher R-Yalues
mean greater insulating power.
Electric Hot Water Heater:
• Cut out for pressure relief valve
• Cut out for heating electric controls
• Cut opening for drain valve
Gas Hot Water Heater:
• Two strips of tape
• Cut out access to pilot light and controls
FIRE HAZARD: To avoid fire, do not place insulation over or within 3 inches of light fixtures or
other electrical devices or fixtures, except where the device or fixture is designed and labeled for
contact with insulation. Do not install insulation adjacent to areas where there are flame or heat
producing sources, including electric heat coils or any similar heat producing device. Do not
place insulation in air spaces surrounding metal chimneys, fireplaces, or flues.
™ COTTON ENHANCED and the Seal of Cotton are trademarks of Cotton Incorporated. This product
contains a minimum of 55% cotton. Insulation material is 80% recycled post consumer content.
This product meets the quality standards of the State of Calilornia.
Scissors
SUGGESTION: Wearing long sleeves, gloves, and eye protection is recommended.
Multiple uses include: Insulation around window air conditioner unit, exterior
wall penetrations, around duct work, basement windows, around doors &
windows and around water pipes.
Seitenansicht 0
1

Inhaltsverzeichnis

Seite 1 - Water Heater Blanket

Manufactured By Bonded Logic, Inc. Chandler, AZ 85248Water Heater BlanketTools Needed:Properly sealing and insulating your home can be an easy way to

Kommentare zu diesen Handbüchern

Keine Kommentare